LecturaInvestigaciónRadarMarco de inversión
Iniciar sesión / Registrarse
← Volver a la lectura
NoticiasTema · 空中操作耦合难题Material3 min de lecturaEditorial de DisconfirmAI

TU Delft Professor Alonso-Mora: The Core Challenge of Drone Operation is the Coupling of Flight Stability and Contact Force

At the IROS 2026 workshop, Javier Alonso-Mora, a professor at Delft University of Technology (Netherlands), explained the essential difference between aerial and ground-based manipulation: the lack of fixed support means that contact forces generated by robotic arms directly destabilize the flying platform. His team addresses this by using hierarchical control—an outer reinforcement learning policy generates manipulation commands while an inner adaptive controller maintains stability—thereby decoupling these two objectives. This approach has been extended to multi-drone cooperative lifting. The author explicitly acknowledges current system limitations, including reliance on motion capture systems, unhandled obstacles, and assumptions of taut cables.

2026-09-30 14:29 GMT+8

When ground robots perform manipulation, there is an implicit premise: the chassis provides fixed support. When a robotic arm pushes a box or tightens a bolt, the reaction force is absorbed by the ground, leaving the robot's own attitude unaffected. Once the same robotic arm is mounted on a drone, however, this premise disappears. Forces generated by the robotic arm's movement or contact with the environment directly alter the drone's attitude and position. Flight stability and manipulation tasks are no longer two independent problems but coupled aspects of the same problem.

Javier Alonso-Mora, a professor at Delft University of Technology (Netherlands), systematically introduced how his team addresses this constraint during the "Tightly Coupled Physical Interaction and Collaboration in Multi-Robot Systems" workshop at IROS 2026.

The Autonomous Multi-Robots Laboratory led by Alonso-Mora uses a platform called the Differential Shoulder Aerial Manipulation Platform (DSAM). Its core design strategy decomposes the coupling problem into two layers: an outer layer where a reinforcement learning policy generates manipulation commands, and an inner layer where an adaptive controller handles stability control. Together, they complete the collaborative operation of the drone and robotic arm. In demonstrations, this drone completed three types of contact operations: pushing boxes, writing on a whiteboard, and tightening bolts.

Iniciar sesión / Registrarse
LecturaInvestigaciónRadarMarco de inversión

Extending from single-unit to multi-unit operations makes the coupling problem more complex. Initially, Alonso-Mora's team used centralized Nonlinear Model Predictive Control (NMPC) to have three drones jointly lift an object via ropes: a central computer uniformly calculated control inputs for all drones. The system could perform trajectory tracking, resist external disturbances, and readjust after the lifted object was impacted. They subsequently attempted to remove this central control unit, switching to multi-agent reinforcement learning. During training, an Actor-Critic architecture was used, where the Critic utilized full state information in simulation to assist policy learning. During actual execution, the Critic was no longer needed; each drone ran only its own Actor network. A high-speed INDI controller operated at the bottom layer to ensure flight stability, with neural networks not directly controlling the lowest-level flight attitudes. In figure-eight trajectory tracking experiments, this distributed strategy performed comparably to centralized NMPC. Even when adding a fourth drone or causing one drone to malfunction, move in the wrong direction, or drop, the strategy demonstrated certain robustness.

However, Alonso-Mora explicitly pointed out current limitations during his presentation. While the centralized scheme could already handle obstacles, the distributed learning scheme had not yet incorporated obstacle avoidance; adding obstacles would significantly increase training complexity and time. The entire system currently still relies on motion capture equipment for positioning and has not achieved fully onboard perception. In multi-drone lifting, the model assumes cables remain taut at all times—this assumption is easily met with three drones and works reasonably well with four, but as the number increases further, some cables may go slack, causing system complexity to rise sharply. When audience members asked how multi-machine coordination could implicitly form, he directly answered, "I'm not sure either," admitting this is a common phenomenon in neural networks where it works but cannot be fully explained.

These limitations are precisely what the HARPA project aims to address. Running from 2026 to 2030, this four-year project aims to enable heterogeneous aerial robot teams to participate in construction work: some drones transport building materials, while others equipped with robotic arms handle module connection and bolt installation. Alonso-Mora stated that the project will continue to advance onboard perception capabilities, reducing reliance on motion capture. From ground to air, from single to multiple units, and from simulation to real-world construction environments, every step increases the complexity of physical constraints.

Fuentes

  • leiphone.com↗
Tema

空中操作耦合难题

【背景】具身智能正从地面移动机器人向空中作业延伸,但“空中操作”面临核心物理约束:无人机没有固定支撑,机械臂产生的接触力会直接破坏飞行平台的稳定性。这一“飞稳与接触力耦合”的难题,是空中机器人能否真正执行拧螺栓、搬运等复杂任务的关键瓶颈。

4 pasos1 piezasActualizado 2026-10-22 12:57

Cómo llegó hasta aquí

  1. 2024-10-10IIIT-H 与东南大学等机构发表《Modular Adaptive Aerial Manipulation under Unknown Dynamic Coupling Forces》,提出无需先验知识即可应对未知耦合力的自适应控制方案。arxiv.org ↗
  2. 2025-10-17塞维利亚大学团队发表《Integration of a Variable Stiffness Link for Long-Reach Aerial Manipulation》,展示通过可变刚度连杆在柔顺性与精度间取得平衡。arxiv.org ↗
  3. 2026-07-06Twente 大学 Antonio Franchi 发表综述《Aerial Manipulation: Contact, Medium Coupling, and the Geometry of Readiness》,重新定义空中操作为与介质耦合的物理交互过程。arxiv.org ↗

Lo que aún está pendiente

  • 分布式强化学习策略何时能摆脱对外部动作捕捉系统的依赖,实现纯机载感知?
  • 在处理非结构化障碍物和缆绳松弛状态时,现有的分层控制或自适应阻抗方案是否具备足够的鲁棒性?
  • HARPA 项目计划在 2030 年结束,其早期阶段(如材料运输)能否验证多异构无人机在真实风扰下的协同稳定性?
Leer el tema completo →
Continuar investigando →